Felt slippers

Before Christmas I was asked by three people if I made felt slippers. I didn’t but one friend was so keen that she sent me a link to instructions on how to make them. So I had a go at making a test pair for myself.

This is the result – not entirely successful. I used three layers of dark red merino and then three layers of grey Icelandic wool, because I thought this would make the outside sturdier – and they do feel quite robust. And they are reasonably symmetrical.

However, there were a couple of problems:

1. They didn’t shrink as much as I expected, so they’re too big for me (and too small for ESP). In my previous experience, the more layers of felt, the greater the shrinkage, so I expected these to shrink quite a lot, especially as there were three layers of merino. The resist I used was about 30% bigger than my foot – but although I fulled for ages, the final slippers refused to shrink any further. I wonder whether it would be easier if I had a form to put inside while fulling, to give the felt something to shrink against.

2. There are some prominent ridges along the sides where the wool bunched up over the edges of the resist. I couldn’t get rid of these, no matter how hard I rubbed. I think the issue here is that the instructions I followed recommended laying out three layers of wool at a time, each at right angles to the previous layer, before turning the resist over and doing the other side. Although I did trim the layers before folding them over on the other side, they were still quite bulky.

Normally I lay out one layer at a time on each side. With six layers of wool, this would obviously more time-consuming, but it might lead to a better result.

With this pair I could get round most of this problem by cutting away more of the felt around the heel to make the slippers more of a slip-on style. But I’ll probably just put them in the box labelled “Lessons learned” and move on!

Published by


Flextiles uses shibori, ecoprinting and felting to create original, one-off upcycled pieces. Extending the life of a garment by an extra nine months reduces its environmental impact by 20-30%.

4 thoughts on “Felt slippers”

  1. Hello do not despair over the slippers,having written the book Felt Style which features slippers and ballet pump style house shoes and having made hundreds of pairs her is what to do.
    Buy a foot last made from polystyrene from Wingham wool, when you think you have felted it down enough put the last in the shoe(i cover my lasts with cling film to make them last longer) then rub away for another 30mins.Then put the whole thing in a pop sox the the top in knot and put in the washing machine,the felt cannot shrink any less than the last inside it and it makes good sturdy felt,when it is on the last pay more attention to the edges around the foot getting avery nice finish on these.
    Take the last out try on if bait tight just keep pushing your foot in until it fits nice they do stretch a bit with wear.Happy felting .

  2. Hi – I’m no felter so cannot give any practical help at all, but the above solution sounds really fascinating. looking forward to the results of this!


  3. Hi Kim, you will get a lot from Chrissie’s book and I have worn to death my slippers. To make them last longer I cut out a piece of yoga mat and stuck it to the soles. Now the inside is wearing down so I will make an inner sole because I don’t want to get rid of them.
    Look forward to your second go.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

This site uses Akismet to reduce spam. Learn how your comment data is processed.